DIY 2 Styles of Slave Bracelets


Usually, Slave Bracelets are more of a summer festival accessory pairing with a boho gipsy vibe, but it's September now and who said these could not be turned into something autumn and winter appropriate? Grab your darker coloured beads, chain and pliers and let's get crafting.






5
Pandahall supplied the materials for this DIY. Bare in mind that the links on this list were created at the date of the video, if any of the links is broken try searching the name of the product on the site.

4 mm jumprings - http://goo.gl/Ue44WI
Bicone black beads 4.5x4mm, hole: 1mm - http://goo.gl/5SSZcM
Seed beads, purple, 4 mm in diameter, hole 1 mm - http://goo.gl/Q4iwCm
Iron twisted chain in platinum, 3x2x0.4mm - http://goo.gl/JxQkkY
Brass Magnetic Clasps, Round, Silver, 11.5x6mm, hole 1.2mm - http://goo.gl/asYRae
Tibetan Style Spacer Beads 5mm in diameter, 4mm long, hole 1.5mm - http://goo.gl/jLuX6g
Stainless Steel Headpins, 50x0.6mm - http://goo.gl/O8M1UO

14 mm clear glass cover and platinum brass charm - http://goo.gl/kPVVR6
10 mm lobster clasp - http://goo.gl/MXpg6b
Green hexagon glitter
Glue or nail polish
Pliers

1st BRACELET






1. Measure your hand, lay it flat on the table and measure from your knuckle and around the finger, from the knuckle until slightly above the wrist bone and around the wrist. A trick to make it easier is to tape washi tape to your hand and use it as a guide to cut the chain.

 Keep in mind that the measurements will be different depending on the style of bracelet.

2. To make the beaded part, if you are using headpins (you can also use wire) , cut the cap on the end, and create a loop instead. To do that, first bend the pin in a 90ยบ angle and then use a plier to twist the end and create the loop. Choose the combination of beads you want to use and add that to the pin. Cut the excess and close it by creating another loop.



3. On the tape with the finger to wrist measurement, in the centre, mark the length of the beads. Since you'll also need to add a clasp mark the size of it on the tape as well.

4. Cut the rest of the chain, using the tape as a guide and put all the pieces together.

5. Try it on to see how it fits, and remove some of the chain links if necessary.

It makes it harder to attach but, I prefer the look of the bracelet without the jump rings so I removed them and attached the pieces again.

2nd BRACELET






1. Fill the bottom of a metal charm with glitter, add a drop of transparent glue or nail polish to the cover and glue it on top of the glitter. Let it dry.

2. Measure your hand using the washi tape trick, for this bracelet, the chain that goes around the finger will connect with the charm at the centre of your hand, so make sure to adapt the measurements.

3. Cut the chain using the tape as a guide and remember to remove a bit of tape from the wrist part to fit the clasp.


4. Attach the pieces together using jump rings or just the chain, and add the clasp as well. Try it on to see how if fits and adjust if necessary.

5. Lay the bracelet on the table and cut two new pieces of chain measuring from the charm to each side of the closure part. Attach them to the previous piece.


Do you also like wearing slave bracelets, even with long sleeved shirts?
Which one is your favourite? 
Talk to you soon,

Daniela